MECHANICAL
01–10–16
3. Inspect the corner seal groove of the rotor by
inserting the SST.
• If 1/2 or more of either end of the SST can be
inserted into the seal groove, replace the
corner seal.
• If 1/2 or more of both ends of the SST can be
inserted into the corner seal groove, replace
the rotor.
Caution
•
••
• Do not push the SST in with force.
•
••
• Keep the SST perpendicular to the seal
groove.
•
••
• When replacing the corner seal, replace
with one that matches the S or L inscription on the rotor.
4. Measure the clearance between the apex seal
groove and the apex seal using a feeler gauge.
• If it exceeds the maximum specification,
replace the apex seal.
• If the clearance is still not within the standard
after replacing the apex seal, replace the
rotor.
Standard clearance
0.042—0.101 mm {0.0017—0.0039 in}
Maximum clearance
0.15 mm {0.0059 in}
End Of Sie
APEX SEAL INSPECTION
CHU011011B10E02
1. Measure the height in the positions shown in the
figure.
• If it is less than the minimum specification,
replace the apex seal.
• Replace the apex seal spring also whenever
replacing the apex seal.
Standard Height
5.3 mm {0.20 in}
Minimum height
4.3 mm {0.17 in}
End Of Sie
49 0839 165
BHJ0110E035
CHU0110E008
BHJ0110E037
Comentarios a estos manuales