Mazda GENUINE C930 V7 620 Manual de instrucciones descargar pdf (Pagina 18)

9-2. Engine stop operation

This operation only applies when the engine has been started with the

remote control.

z Press the stop switch until it

beeps.

The LCD display will appear as

shown on the right. After the send

mark flashes, the send operation is

completed. After the send operation

is completed, the controller will send

an answer back signal.

When the remote control receives a

response from the vehicle, it

indicates the engine stop operation

with a display (on the right) and a

melody.

・ On some vehicle models, the engine also stops when the shift lever is pressed.

・ The controller buzzer will sound if the engine is stopped for reasons other than a

normal engine stop or the pre-set engine warm-up time has elapsed.

Note

Stop switch

Engine stop

Send error

Receive

error

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Sin comentarios

Mazda GENUINE C930 V7 620 Manual de instrucciones Pagina 18